Technical Data Sheet: DynaSpec-22750G-Gloss

Trade Name

DynaSpec

Description

DynaSpec TM Pb Cr Free High Gloss Epoxy Topcoats

Abstract

A two component, high solids epoxy coating for use on the interior of tactical equipment. The color of the coating is available in a wide variety of colors and gloss ranges including high gloss, semi-gloss and lusterless. 

Characteristics

Surface Preparation

Primed Substrates:

Steel - MlL-DTL-53022 or MIL-DTL-53030 Epoxy Primers, , Consult Contract Requirements
Aluminum(Aviation Systems) - MIL-PRF-23377 or MIL-PRF-85582 Epoxy Primers, Consult Contract Requirements
Aluminum/Galvanized/Stainless Steel - DOD-P-15328 or MIL-C-8514C Wash Primer, Consult Contract Requirements
Ductile or Grey Iron Castings - MIL-DTL-53022 or MIL-DTL-53030 Epoxy Primers, Consult Contract Requirements
Plastics - Due to the wide variety of plastic/fiberglass substrates, the system performance should be tested and confirmed on actual substrate.

Do not apply if the application surface temperature is below 45°F (7°C) or above 110°F (43°C), or if the sruface temperature is within 5°F of the dew point It is highly  recommended that sound practices as set forth by SSPC or NACE be followed when preparing a substrate for painting. At a minimum the surface should be clean of all grease, dirt, oil, rust and foreign material that would be detrimental to proper adhesion and desired performance of the coating system being applied.

Mixing Instructions

4 parts Component A to I part 22750G Component B. I-gallon kits are supplied as a short filled gallon of A and a short filled cuart of22750G Comoonent B.

Reduce with 4500-S-81 Epoxy Reducer (MIL-DTL-81772 Type II)

 

Spray Viscosity

Line Specification